1988 Volkswagen Vanagon - Replaced front brake pads, rear brake cylinders, shoes, and drums. Repaired a cracked brake line.

Kubota SVL 90-2 Skidsteer - Replaced high-flow hydraulic coupling block and couplers.

2018 Ford F150 - VVT Solenoid Replacement

2003 Honda CR-V - Replaced the serpentine belt.

2013 Honda Civic - Replaced the starter and starter relay.

Kubota M6131 - Charged AC system, cleaned out heat exchangers, checked battery connections, battery voltage, ignition switch wires.

John Deere 2040 - Changed hydraulic fluid and filter, replaced hydraulic lines on the steering box and replaced tie rods.

1988 Chevrolet 2500 - Diagnosed and replaced a faulty starter

Dodge Charger - Removed a stuck oil drain plug. No problem is too big or small!

2004 Chysler Crossfire - Changed a rear wheelbearing to get him going and scheduled a time to change remaining bearings and brakes next week

2002 Ford Expedition - Cleaned out an Idle Air Control Valve, Diagnosed a bad battery and a fuel pump issue.

2012 Chevrolet Equinox

2004 Ford Taurus - Diagnosed and replaced a faulty starter.

Kubota L2500 - Checked radiator for leaks, checked coolant levels, and blew out clogged radiator

Mahindra 1526L - Installed new hydraulic lines for grapple to prevent binding and snagging.

2014 Chevrolet Cruze - Repaired a wiring issue and ran a diagnostic scan.

2011 Hyundai Elantra - Replaced front and rear brake pads and rotors.

2010 Nissan Cube - Customer complained of a loud knocking noise coming from the front passenger side. Upon inspection I determined the noise

2013 GMC Terrain - Checked wiring and relays, bench tested starter, found it to have a bad solenoid. Installed a new starter

Samsung SE130 Excavator - Fixed multiple wiring issues and replaced a faulty starter

2016 Mahindra Max 26 XL - Unit wouldn't start or move. Found a corroded ignition wire, repaired wire, and replaced clutch.

Link Belt 2650 Excavator - Unit was having engine power issues. Checked injection pump pressures and found them to be below specs.

Massey Ferguson 231S - Replaced oil sending unit, fuel shut-off solenoid, and three point lift ball.

2004 Ford F150 Lariat - Customer complained of grinding noise when turning. Disassembled and replaced both front wheel bearings. Justin Fieg