Massey Ferguson 231S - Replaced oil sending unit, fuel shut-off solenoid, and three point lift ball.

Rats chewed straight through this harness. I soldered each wire back to its correct place on the connector, saving this customer from having

Drained gearbox and refilled, sharpened blades, freed up rusted joints on wings.

Rebuilt rear hydraulic remote couplers, repaired quick attach on loader, and installed a baler monitor.

Installed a new driveline and changed bearings in PTO gearbox.

Rebuilt the left, front final drive and charged the AC.

Changed two roller belts and diagnosed the hydraulics for a stuck check valve on the ejection door. Now it's ready to finish out hay season!

Kubota M6040 - Replaced the AC compressor clutch and checked freon levels. Now, it's blowing snowballs! Justin Fiegel 501-422-2574

Proctor 1030 Camelback PTO Pump - pillar block bearing replacement

Kubota M5-111 Replaced the Loader Control Assembly

Mid PTO drive shaft was not allowing the deck to raise. Freed up the driveline slide shaft and replaced U-joints. Fiegel's Fix It is a...