Kubota SVL75-2 Skidsteer - Full Service: Changed Engine Oil, Oil Filter, Air Filters, Final Drive Gear Oil and Hydraulic Filter, Topped off

Kubota L39 Backhoe - Replaced the fuel pump, replaced injector return pipe, disassembled the backhoe crowd valve, and repaired a stuck relie

Hyundai Robex X35Z-9A - Rethreaded a leaking hydraulic line.

John Deere CT 322 Skidsteer - Repaired a wiring harness.

2015 T650 Bobcat Skidsteer - Inspected the drive belt and tightened it up to factory specs. Justin Fiegel 501-422-2574

Kubota M7060 - Installed new front wheel hub bearings

1996 Dodge Ram 3500 - Replaced a cracked thermostat housing.

Daewoo Excavator - Diagnosed and repaired an electrical issue.

2013 Kubota RTV X900 - Replaced front wheel bearing and 4x4 drive shaft.

Kubota SVL 90-2 Skidsteer - Replaced high-flow hydraulic coupling block and couplers.

Kubota M6131 - Charged AC system, cleaned out heat exchangers, checked battery connections, battery voltage, ignition switch wires.

John Deere 2040 - Changed hydraulic fluid and filter, replaced hydraulic lines on the steering box and replaced tie rods.

Kubota L2500 - Checked radiator for leaks, checked coolant levels, and blew out clogged radiator

Mahindra 1526L - Installed new hydraulic lines for grapple to prevent binding and snagging.

Samsung SE130 Excavator - Fixed multiple wiring issues and replaced a faulty starter

Link Belt 2650 Excavator - Unit was having engine power issues. Checked injection pump pressures and found them to be below specs.

Massey Ferguson 231S - Replaced oil sending unit, fuel shut-off solenoid, and three point lift ball.

Dropped the transmission in this bad boy. Just because I'm not postin, doesn't mean I'm not workin. Many of the jobs I have are multi-day,

Replaced right side spindle assembly on drop axle and installed a new wheel seal on the left side drop axle spindle assembly.

Replaced right side, top track roller and replaced left track idler.

Rebuilt rear hydraulic remote couplers, repaired quick attach on loader, and installed a baler monitor.

Rebuilt the left, front final drive and charged the AC.

Changed two roller belts and diagnosed the hydraulics for a stuck check valve on the ejection door. Now it's ready to finish out hay season!

Kubota M6040 - Replaced the AC compressor clutch and checked freon levels. Now, it's blowing snowballs! Justin Fiegel 501-422-2574